功能原理 Functional principle

(KHB)進口帶安裝孔高壓球閥旋轉控制芯軸使球體從開啟位置切換到關閉位置，系統壓力將球體推向密封碗的無壓側并無泄漏地切斷液流 retz品牌  (KHB) High pressure ball valve with mounting hole at the inlet rotates the control spindle to switch the ball from the open position to the closed position, and the system pressure pushes the ball to the non pressure side of the sealing bowl to cut off the liquid flow without leakage

(KHB3K)進口帶安裝孔高壓三通球閥旋轉控制芯軸使液流按球口形狀換向，同時無泄漏地截?cái)鄬?duì)立的一側。系統壓力把球體推向密封的無壓側。球體無泄漏地截?cái)鄰慕涌?到接口2或3的液流。當流向從接口2或3到接口1時，會有少許泄漏，但取決于壓力。轉向過程中三個接口互相連接。retz品牌 (KHB3K) The imported two position three-way high pressure ball valve rotates the control spindle to make the liquid flow reverse according to the shape of the ball mouth, while cutting off the opposite side without leakage. The system pressure pushes the ball towards the non pressure side of the seal. The ball can cut off the liquid flow from interface 1 to interface 2 or 3 without leakage. When the flow direction is from interface 2 or 3 to interface 1, there will be a little leakage, but it depends on the pressure. The three interfaces are connected to each other during steering

外形尺寸 Overall dimensions

通孔連接尺寸/Full Holes Dimensions

螺紋孔連接尺寸/Thread Holes Dimensions

側面雙邊螺紋安裝孔 Side bilateral threaded mounting hole

注釋：球閥不是設計為流量控制閥，因此要么全開要么全閉以免損壞密封 Note: The ball valve is not designed as a flow control valve, so it is either fully open or fully closed to avoid damaging the seal

為確保工作正確，必須滿足要求的壓力和溫度參數 To ensure correct operation, the required pressure and temperature parameters must be met