基本參數 Basic parameters

規格尺寸Specification and size：G1/2～1"

塑料球閥閥體為PPO或"UPVC"材料，金屬球閥閥體為316不銹鋼材質，采用浮動球直通結構 The plastic ball valve body is made of PPO or "UPVC" material, the metal ball valve body is made of 316 stainless steel, and the floating ball straight-through structure is adopted

塑料閥體：工作溫度0-60℃，工作壓力0-1MPa，EPDM和FFKM橡膠密封材質可選 Plastic valve body: working temperature 0-60 ℃, working pressure 0-1MPa, EPDM and FFKM rubber sealing materials optional

金屬閥體：工作溫度0~120℃、工作壓力0~1.6MPa，EPDM和FFKM橡膠密封材質可選，其中FFKM橡膠密封材質工作溫度0-200℃  Metal valve body: working temperature 0~120 ℃, working pressure 0~1.6MPa, EPDM and FFKM rubber sealing materials are optional, of which the working temperature of FFKM rubber sealing material is 0-200 ℃

性能特點 Performance characteristics

耐久用，輕扭矩，硬密封，耐腐蝕 Durable, light torque, hard sealing, corrosion resistance

1.啟動扭矩小啟閉時間≤3s  Starting torque small opening and closing time ≤3s

負載扭矩小，電耗低，低壓直流電源驅動使用安全，通量大，廣泛替代大小口徑的電磁閥 Low load torque, low power consumption, safe use of low-voltage DC power drive, large flux, widely replace solenoid valves of large and small caliber

2.替換電磁閥不能正常工作的場合，防護等級高，可在相對潮濕的環境中使用 The replacement solenoid valve can not work normally, with high protection level, and can be used in relatively humid environment

替換啟閉動作要求不快的電磁閥應用場合，使用壽命和安全性遠遠優于電磁閥 The service life and safety are far better than those of the solenoid valve when replacing the solenoid valve application where the opening and closing action is not fast

可用于酸、堿等腐蝕性流體應用領域，可遠程控制。防護等級高，可在相對潮濕的環境中使用 It can be used in acid, alkali and other corrosive fluid applications and can be controlled remotely. High protection level, can be used in relatively humid environment

3.密封性能：球芯和閥座配對研磨，貼合度極高，密封優良。因球閥開關時有刮板作用，不易發生卡阻泄漏現象.

Sealing performance: the ball core and valve seat are lapped in pairs, with high fit and excellent sealing. Because the ball valve has the function of scraper when it is opened and closed, it is not easy to get stuck and leak

4.耐磨性能，耐腐蝕性能：球芯和閥座均采用高硬度、高性能的氧化鋁陶瓷，耐磨性和耐腐蝕性特佳，球芯和閥座不容易因磨損和腐蝕導至密封失效，密封壽命長達10萬次以上

Wear resistance and corrosion resistance: the ball core and valve seat are made of high hardness and high performance alumina ceramics, with excellent wear resistance and corrosion resistance. The ball core and valve seat are not easy to lead to seal failure due to wear and corrosion, and the seal life is more than 100000 times

產品結構 Product mix

① 直流/交流減速電機（DC6-24V/AC220V）

② 316L閥桿（根據不同酸堿可選哈式合金鋼B或C）

③ 不銹鋼316閥體 

④ 陶瓷球芯（剛玉陶瓷氧化鋁）

⑤ PPS耐腐蝕密封片 

⑥ 瓷密封片 

⑦ 開關指示燈

控制接線圖 Control wiring diagram

可設定啟閉時間點獨立控制（比如9點20分開，10點20關閉，周一到周日都需設置，周循環The opening and closing time can be set for independent control (for example, the opening and closing time can be set from 9:20 to 10:20, and it needs to be set from Monday to Sunday, with weekly cycle

A、可對星期一至星期日的每一天在不同時間點設置閥門的開/關 The opening/closing of valves can be set at different time points from Monday to Sunday

B、每天最多可設置5組開和關時間點，可設置全天都關閉或者都打開當天全天的開關狀態保持前一天最后一次的開關狀態 You can set up to five groups of open and close time points every day, and you can set the switch status of the whole day to be closed or open, and keep the last switch status of the previous day

C、首次使用或斷電時間超過3天，要校準當前星期和當前時間 If it is used for the first time or powered off for more than 3 days, the current week and time should be calibrated

1、可對星期一至星期日的每一天在不同時間點設置球閥的開/關，每天最多可設置5組開和關時間點。當天開關次數設為“0”時，當天全天的開關狀態保持前一天最后一次的開關狀態 The opening/closing of the ball valve can be set at different time points from Monday to Sunday. A maximum of five groups of opening and closing time points can be set every day. When the switching times of the day are set to "0", the switching status of the whole day remains the last switching status of the previous day

2、適用于DC12V或DC24V球閥 Applicable to DC12V or DC24V ball valve

功能介紹 Function introduction

鎖定與解鎖 Lock and unlock

設置當前時間 Set current time

校對當前星期 Proofread the current week

設置次數 Set times

設置開關時間